20 amp Wall Switch Receiver

RS214W

   

·         Advanced A10 circuitry, X10 Signal Compatible

·         X10 Standard Code (256 Addresses) and X10 compatible

·         Two way powerline communication, reports status upon Status Request command

·         Automatically updates transmitters that have the same address

·         Equipped with a 20A Form A relay

 

The RS214 is an A10 enhanced power line carrier switch receiver controlling a single internal Form A latching relay. It may be remote controlled specifically by its address, or in groups by the commands ALL LIGHTS ON, ALL LIGHTS OFF, or ALL UNITS OFF. These global commands must be configured.

 

When the RS214 local push-button is activated, it will transmit the corresponding Status Reply two seconds later.

 

A status LED verifies power to unit, and guides a simple configuring procedure. The LED on the face is a guide in configuring and also indicates status and power. The RS214 can be configured to any of the standard 256 individual X10 addresses.

 

Note: this unit does not include dimming features.