Dimmable Receiver (micro module)

LW12

   

Automate Fixed Lights

And keep your own light switch!

 

·     Small enough to fit into a wall box behind a standard wall switch. Only 46x46x17 mm

·     Affordable

·     Works with any X10 transmitter/interface

·     Light can still be controlled by a manual wall switch, including dimming (requires momentary mechanism).

·     Does not require a neutral wire, providing simple 2-wire installation

·    Now every light can be automated!

How it Works
The LW12 Dimmable Micro Module can be mounted behind a standard wall switch, even most designer switches. It is an X10 receiver module that can be controlled by any X10 transmitter or interface. The LW12 can also be controlled manually by momentary action wall switches. The LW12 does not require a neutral wire to operate, so no new cabling needs to be provided to the wall switch and installation is as simple as connecting 2 wires in addition to connecting the wall switch.

The LW12 responds to the standard X10 commands like "All Units On", "All Units Off", "All Lights Off" from any X10 controller set to its house code regardless of unit code, or alternatively can be controlled individually with unit commands such as "On", "Off", "Dim" and "Bright".

 

House code and unit code are programmed using any X10 compatible controller. There is an E²PROM that stores the house and unit code even when the power is cut.

 

Technical Data

·         Supply voltage: 230 V +10% -15% 50 Hz

·         Supply current : < 20mA capacitive

·         Making capacity: 250W (Incandescent/Halogen lighting only)

·         Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz

·         Input impedance: 180 Ohms (L - N) at 120 kHz

·         Connections: screw type terminals for phase, neutral and switched phase, wire for switch connection

·         Ambient temperature: - 10° C to + 40° C (operation), - 20° C to + 70° C (storage)

·         Dimensions: 46 x 46 x 17 mm