Do you have
3-phase power? Then you can use the CR244 coupler/repeater to allow
A10/X10 signals to pass through on all of the phases. As well as
coupling the phases, the CR244 will add to the reliability of your
X10/A10 system.
The CR244 repeats A10/X10 power line carrier
transmission signals on all phases of a 230V/400V 50Hz system. The
signal will also be amplified and re-sent on the phase where the signal
was original received from.
Features
-
Repeats both
the signals from MicroModules as well as regular A10/X10
transmitters.
-
Pre installed
in IP54 plastic cabinet: designed to install in the main
distribution box.
-
Status LEDs
on cover.
-
Can also be
used as signal repeater in a one phase installation.
-
Calculates
signals on 2nd and 3rd phase from the 1 phase compatible signals of
MicroModules.
-
Repeats the 3
phase compatible signals of regular X10 transmitters.
-
Two way
-
A10 technology means signals repeated are of higher voltage
to normal X10 signals, giving extra reliability to your system.
-
Fuse
protected.
Applications
LED Display
POWER
CR244 is active
READY
Ready for receiving data
RECEIVE
Receiving data
TRANSMIT
Transmitting data
ERROR
Error in data
Installation
Wiring:
Brown L1 Phase 1 + Power (should always be connected to 230V)
Black
L2 Phase 2
Black
L3 Phase 3
Blue
N Neutral
Yellow/Green
Earth Connection (not connected inside the repeater)
The
CR244 should be installed behind a fuse (e.g. 10A). Normally, the best
location to hook up the CR244 is behind a 3-phase master switch of a
400V power group (e.g. cooking or heating group). When earth leakage
switches are installed, the CR244 should be installed before the earth
leakage switches to prevent the unwanted trigger of the earth leak
switches. When you use a 3-phase earth leakage switch with one neutral
connection, you will be able to connect the CR244 behind it.
Note:
Installation to be performed by a licensed electrical contractor.
