The AW 12 Micro Module can be mounted behind any
standard wall switch, even most designer switches.
It is an X10 receiver module that can be controlled
by any X10 controller or remote control sending X10 signals. The
internal relay can also be tripped by external latched or momentary
action wall switches.
The AW 12 responds to the standard X10 commands like
"All Units On", "All Units Off", "All Lights Off" from any X10
controller set to its house code regardless of unit code or
alternatively individual unit control by "On", "Off".
House code and unit code are programmed using any
X10 compatible controller. There is an E²PROM that stores the house and
unit code even when the power is cut.
Technical Data
-
Supply voltage: 230 V +10% -15% 50 Hz
-
Supply current : < 20 mA capacitive
-
Making capacity: 2000 W ( incandescent lamp)
3 A (motors)
16 A (resistive loads)
-
Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz
-
Input impedance: 180 Ohms (L - N) at 120 kHz
-
Connections: screw type terminals for phase, neutral and
switched phase, wire for switch connection
-
Ambient temperature: - 10° C to + 40° C (operation)
- 20° C to + 70° C (storage)
-
Dimensions: 46 x 46 x 17 mm
