|
 |
|
|
Relay receiver (DIN mount) |
|
|
|
|
The AD10
DIN switch is a receiver module designed to switch hard–wired
circuits.
Receiving X10 commands sent from X10 transmitters, the AD10
enables automation control of your fixed on/off loads. It can also be
switched manually by wiring a continuous or momentary switch to the
input terminals. When using momentary switches it is possible to wire
many switches in parallel for easy wiring of 2-way (or more) switching.
A manual override switch can be set to either force the
AD10 off or on permanently or, when in the 'auto' position, the AD10
will respond to X10 signals and commands from the input switches.
The AD10 may be wired inside a DIN rail enclosure in the
switchboard, or can be installed in a suitable enclosure located in the
roof space above the load to be controlled.
Controls up to 16A resistive loads, 3A motors and 2000W
lamps
